General InformationTripp Lite's SMX500RT1U intelligent, line interactive rack/tower UPS prevents data loss, downtime and equipment damage due to power outages, voltage fluctuations and transient surges. Requires only one rack space (1U) in a 2 or 4 post rack. Large internal batteries offer 17 minutes half load runtime and 5 minutes at full load. Maintains regulated 230V nominal output without using battery power during brownouts as low as 187V. 500VA/300 watt power handling capability. Includes a total of 7 IEC C13 outlets (6 UPS and 1 surge-only receptacle.) Supports simultaneous remote monitoring of UPS and site power conditions via built-in USB, DB9 monitoring ports, and SNMP accessory slot. Includes PowerAlert UPS monitoring and unattended shutdown software with complete cabling. Built-in accessory slot supports SNMP with optional SNMPWEBCARD adapter. Multi-function audible alarms and set of 5 front panel LEDs offer at-a-glance notification of UPS and line power status.Technical InformationPlug/Connector Type: IEC 320-C14Receptacles: 6 x IEC 60320 C13Dataline Protection: RJ-11Emergency Power OFF: YesTransfer Time: 4 msPower DescriptionLoad Capacity: 500 VA/300 WInput Voltage: 220 V ACOutput Voltage: 230 V ACManagementNetwork Management: SNMP ManageableInterfaces/PortsSerial Port: YesUSB: YesBattery InformationBackup/Run Time (Full Load): 5 MinuteBackup/Run Time (Half Load): 17 MinuteTypical Battery Recharge Time: 4 HourPhysical CharacteristicsHeight: 1.8"Width: 17.5"Depth: 11.8"Rack Height: 1UForm Factor: TowerWeight (Approximate): 18 lbMiscellaneousPackage Contents: SmartPro 500VA Rack-mountable TowerSMX500RT1U UPS System with mounting hardwareTwo 1.8m IEC320-C13 to C14 load jumper cablesCabling for USB & DB9 monitoring and EPO switchingPowerAlert unattended shutdown and UPS/Power monitoring softwareWarranty informationAdditional Information: Switches: Includes 2 front panel mounted push-button switches for system enable, self-test and alarm cancel functionsLow voltage transfer to battery power: 187V (resets to line power as line voltage increases to 195V or higher)High voltage transfer to battery power: 264V (resets to line power as line voltage decreases to 256 or lower)Cold Start: Yes, inverter can be "cold started" to enable temporary AC output during a power failureCertifications & Standards: CE EN62040 listed, RoHS-CompliantSoftware Included: PowerAlert UPS monitoring softwareWarrantyLimited Warranty: 2 Year OUTPUT Output Volt Amp Capacity (VA): 500 Output Watt Capacity (Watts): 300 Power Factor: 0.6 Nominal Output Voltage(s) Supported: 220V 230V 240V Nominal Voltage Details: 230v nominal inverter output voltage Frequency Compatibility: 50 / 60 Hz Frequency Compatibility Details: Automatic frequency selection Output Voltage Regulation (Line Mode): -8%, +15% Output Voltage Regulation (Battery Mode): +/- 5% Output Receptacles: (7) C13 Included Output Power Cables: Two 1.8m IEC320-C13 to C14 load jumper cables UPS Output Receptacles (Surge Suppression Only): 6 UPS outlets, 1 surge-only outlet Load Management Receptacles: One switchable single-outlet C13 load bank Hot-Swap PDU options: PDUBHV10 (2U / 8 C13 outlets) Output AC Waveform (AC Mode): Sine wave Output AC Waveform (Battery Mode): PWM sine wave Individually Controllable Load Banks: No INPUT Rated input current (Maximum Load): 2.4A Nominal Input Voltage(s) Supported: 230V AC UPS Input Connection Type: C14 inlet UPS Input Connection Description: C14 inlet accepts user-supplied AC power cord with country-specific plug Input Circuit Breakers: 8A Input Phase: Single-Phase BATTERY Full Load Runtime (min.): 3.2 min. (300w) Half Load Runtime (min.): 14.6 min. (150w) DC System Voltage (VDC): 12 Battery Recharge Rate (Included Batteries): Less than 4 hours from 10% to 90% (typical, full load discharge) Internal UPS Replacement Battery Cartridge: RBC62-1U Battery Access: Battery access door Battery Replacement Description: Hot-swappable, user replaceable batteries Expandable Runtime: No VOLTAGE REGULATION Voltage Regulation Description: Automatic voltage regulation (AVR) maintains line power operation with input voltage as low as 187 Undervoltage Correction: Input voltages between 187 and 215 are boosted by 14% USER INTERFACE, ALERTS AND CONTROLS Switches: 2 Switches control off/on power status and alarm-cancel/self-test operation Alarm Cancel Operation: Power-fail alarm can be silenced using alarm-cancel switch once silenced, alarm will re-sound to indicate low-battery status Audible Alarm: Audible alarm indicates power-failure, overload and low-battery conditions LED Indicators: 5 LEDs indicate line power, battery power, overload, voltage regulation and battery low/replace status SURGE / NOISE SUPPRESSION UPS AC Suppression Joule Rating: 480 EMI / RFI AC Noise Suppression: Yes PHYSICAL Included Mounting Accessory Description: Included mounting flanges support rackmount installation in 2 or 4 post racks Primary Form Factor: Rackmount UPS Power Module Dimensions (hwd, in.): 1.73 x 17.32 x 11.61 Rack Height (U Spaces): 1 Minimum Required Rack Depth (inches): 13.86 UPS Housing Material: Steel Primary UPS Height (mm): 44 Primary UPS Width (mm): 440 Primary UPS Depth (mm): 295 COMMUNICATIONS Communications Interface: USB (HID enabled) DB9 Serial EPO (emergency power off) Slot for SNMP/Web interface Network Management Cards: SNMPWEBCARD TLNETCARD WEBCARDLX Network Monitoring Port Description: Supports detailed monitoring of UPS and site power conditions PowerAlert Software: For local monitoring via the UPSs built-in communication ports, download PowerAlert Local software at http://www.tripplite.com/poweralert Communications Cable: USB and DB9 cabling included WatchDog Compatibility: Supports Watchdog application, OS and hard-reboot restart options for remote applications Network UPS Tools Compatibility: NUT compatible. See the full list of Tripp Lite NUT compatible UPS systems at networkupstools.org/stable-hclLINE / BATTERY TRANSFER Transfer Time: 2-4 milliseconds Low Voltage Transfer to Battery Power (Setpoint): 187 High Voltage Transfer to Battery Power (Setpoint): 264 SPECIAL FEATURES Grounding Lug: Back panel grounding lug Cold Start (Startup in Battery Mode During a Power Failure): Cold-start operation supported High Availability UPS Features: Hot swappable batteries Green Energy-Saving Features: Greater than 95% efficiency - GREEN UPS Individually controllable load banks CERTIFICATIONS UPS Certifications: Additional certifications CE ROHS (Restriction of Hazardous Substances) Tested to EAC (Belarus, Kazakhstan, Russia) UPS Certification Details: LVD 2014/35/EU EMC 2014/30/EU EN 62040-1: 2008+A1: 2013 EN 62040-2: 2006+AC: 2006 Item Dimension (L"xW"xH") 5 x 16 x 22
